KitchenAid Artisan Mixer Speed Control Lever Knob Repair Kit Black PETG

3D Printed Speed Control Knob for KitchenAid Artisan Stand Mixers —

Two knobs, black PETG. For the Artisan speed lever — a 2.1 mm thick blade. Measure yours before ordering.

Part Details

• Material: PETG — chosen for its impact resistance and thermal stability over standard PLA, which softens and goes brittle over a mixer's service life. The model's designer recommends black ABS or PETG for this part specifically.
• Quantity: 2 knobs
• Color: Black
• Lever socket: 2.10 mm thick, tapering 4.44 mm to 3.41 mm in width, approximately 10 mm deep, with a chamfered lead-in
• Knob size: 17.9 × 18.0 mm, 15.1 mm tall
• Ships from: United States
• Brand: Unbranded aftermarket replacement

Why This Knob Breaks

It is a small plastic knob pressed onto a thin metal lever that gets worked through its full travel every time the mixer runs. The plastic splits at the socket and the knob drops off, leaving a bare metal lever that still changes speed but is awkward and sharp to use. Nothing mechanical or electrical has failed at that point, which is why a knob is the whole repair.

Compatible Models

KitchenAid Artisan tilt-head stand mixers, speed selection lever. Fit is set by the lever blade and not by the badge on the mixer, so the 2.10 mm thickness above is a better guide than any model list. This knob is sized differently from the other common KitchenAid knobs: it will not fit the large 3/16" lever used on many Classic-style mixers, the small 1/8" lever, or the Professional 600 bowl-lift, whose speed lever is too thick to enter this socket. If your lever measures thicker than 2.10 mm, this is the wrong part.

KitchenAid is a registered trademark of Whirlpool Corporation. PartsFindr is not affiliated with, endorsed by, or sponsored by KitchenAid or Whirlpool. Original 3D model design by frederictost, licensed under Creative Commons Attribution.